Installation method of steel plate+glass wool insulation materials on steel buildings

The installation method of steel plate + glass wool insulation material on steel buildings mainly includes the following steps:

Base preparation: Ensure that the surface of the steel structure is dry and flat, without sharp protrusions to avoid puncturing the insulation cotton.

Cutting glass wool: Cut the glass wool according to the design requirements and actual site conditions to ensure that the size and thickness meet the requirements.

Laying glass wool: Lay the cut glass wool on the steel structure, and pay attention to keep the cotton layer flat and wrinkle-free.

Laying steel plate: Place the insulation board cut to size on the glass wool insulation material and fix it with self-tapping screws. Pay attention to the flatness and fit of the steel plate when fixing it, and seal the steel plate with plastic corner seals to prevent leakage and deformation of the sealing strip.

Inspection and adjustment: Check the entire installation process to ensure that there are no omissions and the insulation effect is good. If necessary, adjust the parts that do not meet the requirements.

Precautions

During the installation process, ensure that the construction site is clean and tidy to avoid debris from mixing into the insulation material.

Follow the safety operating procedures and wear personal protective equipment to avoid accidental injuries.

Pay attention to the storage and transportation of insulation materials to avoid moisture and damage.

Regularly check the installation of insulation materials, and repair them in time if they are loose or damaged.